It's time for my first belt change on my Cocoatown Melanger. Inno Concepts tells me that I shouldn't attempt this myself, and that the motor "may" need to be removed in order to change the belt. Has anyone on this forum done this themselves? I'm a newbie.
I'd really recommend switching to the PowerTwist fiberglass link belt that Felipe linked above. They don't stretch and you'll probably never need to replace it. I ran a few Cocoatown ECGC-12s for 3 years or so using them without ever having to change or tighten the belt.
Thank you Katherine for the tip. However, I am here in Ecuador and it's a real challenge to find the replacement with that information. But I did manage to find on today after visiting a million shops. Hope it works.
I will however with more time look for a fiberglass link belt that Ben mentions because it is a real hassle to change these belts so often and with less luck the motor will get damaged. Do you know how many cm or inches the fiberglass link is for the ECGC12?
The older model ECGC12 that I had used a 3/8" width belt. I'm not sure what the newer model ECGC12SL uses, but I'd assume it is the same. I don't know how long it was/is, but it doesn't really matter since the link belt's length is easily adjusted.
Great! Thank you so much.
Could you tell me an approximate length on that belt? I'm looking to order one of the Powertwist belts.
If I remember correctly, I think the belts on the small melangers are about 3 feet long.