The Chocolate Life

Discover Chocolate and Live La Vida Cocoa!

Hello everyone including all lurkers!

I saw the Micelli polycarb molds advertised on the Chocolate Life but I am looking for a much larger industrial mold. I am looking for a mold that is 24" x 16".  Anyone have any suggestions on who to contact for this size of mold?

Your help is much appreciated!

Thank you.

Jeffray D. Gardner

Marsatta Chocolate

Views: 165

Reply to This

Replies to This Discussion

That's pretty big for polycarbonate - essentially the dimensions of a full sized sheet pan.  You might want to consider a thermoformed mold and the use a sheetpan to help stabilize it.

 

 

Thanks for your reply Brad. I appreciate it! I'll check it out. Do you know if there is a big difference in terms of the material used? I am actually looking to create small cavities or inclusions within the large mold that will be approx. 1/4 inch square in size so you can imagine just how many cavities it would hold. Thanks again.

Go Flames Go! 

1/4 inch in size eh?  Hmmm.... Thermoformed mold probably won't work for you.  Essentially what thermoformed mold is a sheet of heavy plastic laid over top of a "negative" of the mold, heated almost to melting point, and then sucked down on to the negative by vacuum pressure.  The detail is nowhere near the clarity of polycarbonate, and is certainly not going to get you the 1/4 inch inclusion squares you want.

 

Polycarbonate molds are essentially little pellets of plastic that are melted and then forced into a metal mold shape under intense pressure and heat.  The plastic cools and then the mold is popped open to let out the molded shape - which is usually very hard and clear (some are white).  A machine that could handle a 2 foot sized mold would be huge.  I'm sure they are out there, but holy cow your molds will be expensive.  Prepare to sell off your first born for those bad boys!

 

My suggestion would be to create a negative out of wood, or molding clay, or something like that, and then use silicone.  You can then make your own.  There are lots of videos online to do that, and most cities have craft stores where silicone molding supplies are sold.

 

Hope that helps.

Thanks for explaining the differences Brad. Your right about expensive! I was getting quotes of $5,000 +... yikes! I like your suggestion as I need my Oompa Loompas for future work!

I am going to try and see what I come up with. Definitely I see a challenge.

Cheers!

RSS

Member Marketplace

Promote TheChocolateLife

Bookmark and Share

Follow Clay on:
Twitter :: @DiscoverChoc
F'Book :: TheChocolateLife
F'Book Group :: LaVidaCocoa
Paper.li :: @DiscoverChoc

Badge

Loading…

© 2014   Created by Clay Gordon.

Badges  |  Report an Issue  |  Terms of Service